Yealink MeetingBoard 86 - Power Management and Status Indicators; Power On Procedure; LED Indicator Meanings; Power Off Procedure

6
1. Insert the end of the power cable into
the power port of the endpoint.
2. Insert the power cord plug into the
outlet.
3. Turn the rocker switch button on the
right rear of the endpoint to "I" to turn on
the endpoint.
Turn the rocker switch button on the right rear of the
endpoint to "O" to turn off the endpoint.
Upon rst power-on of the endpoint, follow the on-screen setup wizard to congure
language, time, network, etc., to initialize the conguration. The initialization opera-
tions vary with software versions.
4
Power on
1
2
3
5
LED Status
Status
Roll green light
from inside to
outside at the
same time
Slow-
ly-ash-
ing green
Rolls green
light from left
to right
Flashing
red
Off Solid green Solid red
Description
• Booting
• Shutting down
Sleep
mode
• Firmware
upgrading
• Factory
resetting
Abnormal
• Power
off
• Not in a
call
Unmuted
during a call
Muted
during a call
6
Power outage
After the endpoint is started for the rst time or restored to factory settings, go to set-
tings on the touchscreen to congure the admin password (default password:0000).