Yealink MeetingEye 400 Administrator's Guide

| Accessories with Your System | 252
MeetingEye 600/MeetingEye 400/VC880/VC800/VC500/VC200-E/PVT980/PVT9500 supports the CEC
feature by default. Make sure that the display you connect supports CEC feature and you enable the
feature.
The following CEC features are available:
• One Touch Play-Use the system remote control to wake up the monitors. All connected CEC-capable
monitors are powered on, and their displays are switched to VCS input.
• System Standby-When the VCS enters sleep mode, all connected CEC-capable monitors are switched
to standby mode for power saving.
Note:
The VCS does not respond to CEC commands issued by a television remote control.
• Configuring CEC Monitor Controls
Configuring CEC Monitor Controls
Procedure
1. On your web user interface, go to Setting > Display/Monitor > Display Function.
2. Configure and save the following settings:
Parameter Description Configuration Method
CEC Enable
Enable or disable the CEC
feature.
Default: Disabled.
Web user interface
Accessories with Your System
This section describes the how to use the accessories. For more information on other accessories, refer to
related guide.
• Using WPP20 Wireless Presentation Pod
• Using the CPN10 PSTN Box
• Using the VCC22 Video Conferencing Cameras
• Using the CPW90-BT Bluetooth Wireless Microphones with VCS
• Using VCM34
• Using VCM38
• Using the Soundbar/MSpeaker II
• Using CP900/CP700 Ultra-Compact Speakerphone
Using WPP20 Wireless Presentation Pod
For VC880/VC800/VC500/PVT980/PVT950, you can pair with up to 5 WPP20s for content sharing at the
same time. However, for MeetingEye 600/MeetingEye 400/VC200/VC200-E/VP59, only 1 WPP20 can be
supported.
For more information, refer to Yealink WPP20 Wireless Presentation Pod Quick Start Guide.

Yealink MeetingEye 400 Specifications

General

Brand	Yealink
Model	MeetingEye 400
Category	Conference System
Language	English