Why can't I adjust the camera on my Yealink MeetingEye 600?
If you cannot adjust the camera angle and focus on your Yealink Conference System, select the local image using your remote control before attempting to adjust the camera. Ensure the system is idle or during a call, and check the remote control.
Why do I fail to call far site on my Yealink MeetingEye 600?
If you fail to call the far site using your Yealink Conference System, the far site may have enabled Do Not Disturb (DND) mode. Contact the far site and ask them to disable DND.
What to do if I forget the admin password for my Yealink MeetingEye 600 Conference System?
To regain access to advanced settings on your Yealink Conference System after forgetting the administrator password, reset your system.
Why is the video quality poor on my Yealink MeetingEye 600?
If the video quality is poor on your Yealink Conference System, adjust the monitor resolution and camera parameters like brightness and white balance. Check call statistics for packet loss and contact your network administrator if necessary. Avoid high-intensity indoor light or direct sunlight on the camera.
Why can't I share content on my Yealink MeetingEye 600 Conference System?
If you cannot share content from your Yealink Conference System, ensure your PC is properly connected and turned on. If you're using a VCH50/VCH51 video conferencing hub or WPP20 wireless presentation pod, try replacing it. If using a WPP20, ensure it's connected to the video conferencing system to obtain the Wi-Fi profile and that the wireless AP feature of the video conferencing system is enabled.
How to prevent monitor burn-in on Yealink MeetingEye 600?
To prevent monitor burn-in on your Yealink Conference System, configure the automatic sleep time or use a screen saver. Additionally, decrease the monitor's sharpness, brightness, and contrast settings if they are set to their maximum values.
What to do if the picture is blank on my Yealink MeetingEye 600 monitor?
If the picture is blank on the monitor connected to your Yealink Conference System, press any key on the remote control to wake the system if it's in sleep mode. Ensure the system is powered on and that the HDMI cable is securely connected to both the system and the monitor, and that the monitor is also powered on.
How to fix Yealink MeetingEye 600 remote control not working?
If your Yealink Conference System does not respond to the remote control, replace the batteries, ensure they are correctly installed, and aim the remote control directly at the sensor when performing tasks.
Why can't I receive calls on my Yealink Conference System?
If you cannot receive calls on your Yealink Conference System, ensure your network is available or contact your network administrator. Also, verify that your account is registered and that Do Not Disturb (DND) mode is disabled.
Why is the audio unclear on my Yealink MeetingEye 600 during a call?
If you cannot hear the audio clearly during a call on your Yealink Conference System, try adjusting the speaker volume. If the audio from the far site is muffled, they may be in a highly reverberant room—advise them to speak closer to their phone. Check your audio codec priority, enable noise suppression, and ensure the device is clean and free of dust.
General| Brand | Yealink |
|---|---|
| Model | MeetingEye 600 |
| Category | Conference System |
| Language | English |
To Next Page
