E
N
G
L
I
S
H
3
Conguring Your Phone
Conguring via web user interface
Accessing the web user interface:
1. Press the
OK
key when the phone is idle to get the IP address of the phone.
2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,
“http://192.168.0.10” or “192.168.0.10”) and press
Enter
.
3. Enter the user name (default: admin) and password (default: admin) in the login page and
click
Conrm
.
Note:
Please locate your computer in the same network segment of the IP phone (192.168.0.X) to access
the web user interface. Contact your system administrator for more information.
Network Settings:
Click on
Network->Basic->IPv4 Cong
You can configure the network in the following ways:
DHCP:
By default, the phone attempts to contact a DHCP server in your network to obtain
its valid network settings, e.g., IP address, subnet mask, gateway address and DNS
address.
Static IP Address:
If the phone cannot contact a DHCP server for any reason, you need
to configure IP address, subnet mask, gateway address, primary DNS
address and secondary DNS address for the phone manually.
PPPoE:
If you are using an xDSL modem, you can connect your phone to the Internet via
PPPoE mode. Contact the ITSP for the user name and password.
Note:
The wrong network settings may result in inaccessibility of the phone and may have an impact on
the network performance. Contact your system administrator for more information.
Account Settings
: Click on
Account->Register->Account X
(X=1, 2)
Parameters of the account:
Register Status: It shows the register status of the current account.
Line Active: You can select Enabled/Disabled to enable/disable the account.
Label: It is shown on the LCD to identify the account.
Display Name: It is shown as caller ID when placing a call.
User Name: It is provided by ITSP for registration (required).
Register Name: It is an authenticated ID for authentication provided by ITSP (required).
Password: It is provided by ITSP for registration (required).
Server Host: It is provided by ITSP for registration (required).
Register status icons on the LCD screen:
Registered Register Failed Registering
Note:
Check with your system administrator if any error appears during the registration process or a
specific configuration is required for your registration.
Conguring via phone user interface
Network Settings:
Press the
Menu
soft key when the phone is idle, select
Settings->Advanced Settings
(password: admin)->Network->WAN Port/VLAN/Webserver Type/802.1x Settings/VPN
to
configure the network.
Account Settings:
Press the
Menu
soft key when the phone is idle, select
Settings->Advanced Settings
(password: admin)->Accounts
to configure the account.
Note:
For more information on account parameters, refer to
Conguring via web user interface
.
To Next Page
Loading...
Need help?
General
