Yealink SIP- T28P - Manual Configuration

PaloSanto Solutions
Yealink SIP-T28P Server Setup Guide
7
MANUAL CONFIGURATION
1. Use the information from the Add SIP Extension page (Figure 4-4) to enter the
following necessary information on “Account => Account 1” section of the Yealink
Phone WebUI:
 Line Active: ON
 Display Name: YealinkUser
 Register Name: 301 in this example
 User Name: 301 in this example
 Password: ‘h7Dka3Rf9si0t’ in this example
 SIP Server: Elastix Server’s IP Address (192.168.1.65 in this example)
Figure 4-8. Account
2. Once you have entered the required information, click on “Confirm” button located at
the end of the page. The phone should be registered now. To check this, refresh the
current page and see the Register Status of the account. If the phone is not registered,
make sure you’ve entered the correct information (Figure 4.9).
Figure 4.9. Register Status
3. Configure the other IP (SIP) Phone with the correct parameters.
PaloSanto Solutions
Yealink SIP-T28P Server Setup Guide
7
MANUAL CONFIGURATION
1. Use the information from the Add SIP Extension page (Figure 4-4) to enter the
following necessary information on “Account => Account 1” section of the Yealink
Phone WebUI:
 Line Active: ON
 Display Name: YealinkUser
 Register Name: 301 in this example
 User Name: 301 in this example
 Password: ‘h7Dka3Rf9si0t’ in this example
 SIP Server: Elastix Server’s IP Address (192.168.1.65 in this example)
Figure 4-8. Account
2. Once you have entered the required information, click on “Confirm” button located at
the end of the page. The phone should be registered now. To check this, refresh the
current page and see the Register Status of the account. If the phone is not registered,
make sure you’ve entered the correct information (Figure 4.9).
Figure 4.9. Register Status
3. Configure the other IP (SIP) Phone with the correct parameters.
PaloSanto Solutions
Yealink SIP-T28P Server Setup Guide
7
MANUAL CONFIGURATION
1. Use the information from the Add SIP Extension page (Figure 4-4) to enter the
following necessary information on “Account => Account 1” section of the Yealink
Phone WebUI:
 Line Active: ON
 Display Name: YealinkUser
 Register Name: 301 in this example
 User Name: 301 in this example
 Password: ‘h7Dka3Rf9si0t’ in this example
 SIP Server: Elastix Server’s IP Address (192.168.1.65 in this example)
Figure 4-8. Account
2. Once you have entered the required information, click on “Confirm” button located at
the end of the page. The phone should be registered now. To check this, refresh the
current page and see the Register Status of the account. If the phone is not registered,
make sure you’ve entered the correct information (Figure 4.9).
Figure 4.9. Register Status
3. Configure the other IP (SIP) Phone with the correct parameters.