To Next PageTo Next Page
Need help?Do you have a question about the Yealink SIP-T28 and is the answer not in the manual?
General| Power Supply | AC 100-240V, 50/60Hz |
|---|---|
| SIP Accounts | 6 |
| Headset Port | Yes (RJ9) |
| HD Audio | Yes |
| Network | 10/100 Mbps Ethernet |
| Audio Codec | G.711, G.729, G.722, iLBC |
| Protocols Supported | SIP |
| Ethernet Ports | 2 (10/100 Mbps) |
| PoE Support | Yes |
| Voice Codecs | G.711, G.729, G.722, iLBC |
| Speakerphone | Yes, full-duplex |
| Network Ports | 2 (10/100 Mbps) |
| Codecs | G.711, G.729, G.722, iLBC |
| Expansion Module Support | Yes |
Configures code for auto provision URL. Enables phone to update from server address.
Enhances headset usage with priority and dual headset connection capabilities.
Adds multicast paging and music on hold server features for enhanced communication.
Enables SNMP monitoring and displays Caller-ID from remote phonebooks.
Configure code for auto provision URL. Phone updates from server address.
Enables headset as default for calls, switching automatically. Disabled by default.
Allows two headsets to connect; one to headset, one to handset port. Disabled by default.
Configure multicast IP addresses for paging via DSS Key or Contacts.
Play music during call hold via SIP URI. Server support needed.
Displays names from remote phonebook for incoming calls. Disabled by default.
Optimizes ACD and synchronizes status between phone and webpage. Server support needed.
Retrieve phone information via servers using SNMP. Supports 3 trusted addresses.
Allows phone to display XML info from SIP Notify messages. Disabled by default.
Displays caller/transferrer names for forwarded calls. Server support needed.
Shows account registration status in the webpage status section.
Prompts user to update webpage changes after a call ends.
Ensures the phone webpage functions correctly with IE9 browser.
Adds CosmoCom as an option for SIP Server Type, with specific registration behavior.
Restricts 'How to INFO DTMF' configuration when Inband or RFC2833 is selected.
Allows configuration of hold tone playback and delay time. Enabled by default.
