Audio Features
162
For other phones:
A tone is comprised of at most four different frequencies.
Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.
You can configure at most eight different tones for one condition, and separate them by commas. (for
example, 250/200,0/1000,200+300/500,200+500+800+1500/1000).
If you want the IP phone to play tones once, add an exclamation mark “!” before tones (for example,
!250/200,0/1000, 200+300/500,200+500+800+1500/1000).
Note: It works only if “voice.tone.country” is set to Custom.
Permitted
Values
String
Default
Blank
Web UI
Settings > Tones > Dial
Parameter
features.partition_tone
[1]
<y0000000000xx>.cfg
Description
It enables or disables the phone to play the different dial tones when there is no active account.
Note: It works only if “voice.tone.dial” is configured.
Permitted
Values
0-Disabled
1-Enabled. If there is an active account, the phone will play the default dial tone. If there is no active
account, the phone will play the dial tone configured by “voice.tone.dial”.
Default
0
Parameter
voice.tone.secondary_dial <y0000000000xx>.cfg
Description
It customizes the secondary dial tone.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this warning tone, set
it to 0.
Permitted
Values
String
Default
350+440/3000
Web UI
Settings > Tones > Secondary Dial
Parameter
voice.tone.ring <y0000000000xx>.cfg
Description
It customizes the ringback tone.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this warning tone, set
it to 0.
Permitted
Values
String
Default
Blank
Web UI
Settings > Tones > Ring Back
Parameter
voice.tone.busy <y0000000000xx>.cfg
To Next Page
Loading...
Need help?
General
