EasyManuals Logo

Yealink SIP-T53W Administrator's Guide

Yealink SIP-T53W
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #366 background imageLoading...
Page #366 background image
Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
363
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC
3435. It works only if “account.X.dialplan.digitmap.enable is set to 1 (Enabled). The value configured
by the parameter “account.X.dialplan.digitmap.string takes precedence over that configured by the
parameter “dialplan.digitmap.string”.
Permitted
Values
String within 2048 characters
Default
Blank
Parameter
account.X.dialplan.digitmap.interdigit_long_timer
[1]
<MAC>.cfg
Description
It configures the time (in seconds) to wait before dialing an entered number if it matches part of any
string of the digit map for the account X.
If it is set to 0, the phone will not dial the entered number if only a partial match exists.
The value of this parameter should be greater than that configured by the parameter “accoun-
t.X.dialplan.digitmap.interdigit_short_timer”.
For example:
account.1.dialplan.digitmap.string = 1xxT|xxxxx<T1 >
account.1.dialplan.digitmap.interdigit_long_timer = 10
account.1.dialplan.digitmap.interdigit_short_timer = 5
When you enter 1, it matches part of two-digit maps, the phone tries to wait 10 seconds and then dials
out 1 if no numbers entered;
When you enter 15, it also matches part of two-digit maps, the phone tries to wait 10 seconds and then
dials out 15 if no numbers entered;
When you enter 153, it also matches part of two-digit maps, the phone tries to wait 10 seconds. But
after waiting for 5 seconds, it completely matches the first digit map and then immediately dials out
153.
Note: It works only if “account.X.dialplan.digitmap.enable is set to 1 (Enabled). The value configured
by the parameter “account.X.dialplan.digitmap.interdigit_long_timer” takes precedence over that con-
figured by the parameter “dialplan.digitmap.interdigit_long_timer”.
Permitted
Values
Integer from 0 to 255
Default
Blank
Parameter
account.X.dialplan.digitmap.interdigit_short_timer
[1]
<MAC>.cfg
Description
It configures the timeout interval (in seconds) for any string of digit map.
The phone will wait this many seconds before matching the entered digits to the dial plan and placing
the call.
Note: It works only if “account.X.dialplan.digitmap.enable is set to 1 (Enabled). The value configured
by the parameter “account.X.dialplan.digitmap.interdigit_short_timer” takes precedence over that con-
figured by the parameter “dialplan.digitmap.interdigit_short_timer”.
Permitted
Values
Single configuration (configure a specific value for the timer letter “T” for all strings with “T” of the digit
map)
Example:
account.1.dialplan.digitmap.interdigit_short_timer = 5
If “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|0T, the phone will wait 5 seconds before matching
the entered digits to this dial plan and placing the call.

Table of Contents

Other manuals for Yealink SIP-T53W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink SIP-T53W and is the answer not in the manual?

Yealink SIP-T53W Specifications

General IconGeneral
MountingDesk/Wall
Handset typeWired handset
Product typeIP mobile phone
Product colorGray
Keypad illuminationYes
Wi-Fi standards802.11a, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth version4.2
Security algorithmsAES, HTTPS, SIPS
Networking standardsIEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN interface typeGigabit Ethernet
Supported network protocolsFTP/TFTP/HTTP/HTTPS
Dual-Tone Multi-Frequency (DTMF) modesIn-band, Out-of band, SIP info
USB 2.0 ports quantity1
Ethernet LAN (RJ-45) ports2
Lines quantity8 lines
Phonebook capacity1000 entries
Number of VoIP accounts12
AC adapter input voltage100 - 240 V
AC adapter output current1.2 A
AC adapter output voltage5 V
Power consumption (typical)2.3 W
Volume controlButtons
Number of programmable keys8
Storage temperature (T-T)-30 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Display diagonal3.7 \
Display resolution360 x 160 pixels
Cables includedLAN (RJ-45)
Number of handles included1 pc(s)
Number of DECT wireless handsets4
Voice codecsG.722, G.723.1, G.726, G.729A, G.729B, OPUS, iLBC
Weight and Dimensions IconWeight and Dimensions
Depth210.6 mm
Width212 mm
Height174.5 mm

Related product manuals