Yealink SIP-T54S - Page 1006

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
980
http://<phoneIPAddress/servlet?p
=network-adv&q=load
Details of the Configuration Parameter:
Parameter
Permitted Values
Default
static.network.span_to_pc_port
0 or 1
0
Description:
Enables or disables the IP phone to span data packets received from the Internet port to
the PC port.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), all data packets from Internet port can be received by PC port.
Note: It is not applicable to CP860/CP920 IP phones. It works only if the value of the
parameter “static.network.pc_port.enable” is set to 1 (Auto Negotiation). If you change
this parameter, the IP phone will reboot to make the change take effect.
Web User Interface:
Network->Advanced->Span to PC->Span to PC Port
Phone User Interface:
None
To enable span to PC port via web user interface:
1. Click on Network->Advanced.