Yealink T4 Series – Placing Calls
You can place a call in one of four ways using your SIP-T4 Series IP phone:
• Using the handset
• Using the speakerphone
• Using the headset
• Using the ITC Cloud portal, refer to www.itccloud.com for additional portal training.
You can also dial the number first, and then choose the way you want to speak to the other party.
You can also search and dial a contact from call history, local directory, or remote phone book.
During a call, you can alternate between Speakerphone, Headset, and Handset modes by pressing the
Speakerphone key, the HEADSET key, or by picking up the handset. You can also alternate between the
previous modes to a mobile device and vice versa by dialing *88 either on your IP phone or mobile device.
The call duration of the active call and far-site’s information (name or phone number) are visible on the LCD
screen. In the figure below, the call to “1026” (the phone number: 1026) has lasted 15 seconds.
To place a call using the handset:
1. Pick up the handset.
2. Enter the desired number using the keypad.
3. Press or the Send soft key.
The # key is configured as a send key by default. You can also set the * key as the send key or set neither.
To place a call using the hands-free (speakerphone) mode:
Do one of the following:
- With the handset on-hook, press or the line key to obtain a dial tone.
Enter the desired number using the keypad.
Press or the Send soft key.
- With the handset on-hook, enter the desired number using the keypad.
Press or the Send soft key.
To Next Page
Need help?
General
