How to Connect Trixbox to NeoGate TA FXS Gateway
13/15
Dial Pattern Template: choose the Dial Pattern Template,
DialPatternTemplate1(1).
Note: You don't need to fill in any authentication name and authentication
password on the FXS port edit page if you choose SPS/SPX mode.
After saving and applying the changes, you will see the trunk is “OK” in “Line
Status”.
Path:StatusSystem StatusPort Status
Figure 16. FXS Port Status
Step 5. Create an inbound route on Trixbox.
Path: PBX→PBX Settings→Inbound Call Control→Inbound Routes
Choose the inbound destination as IVR, when you call in Trixbox from NeoGate
TA3200, you will hear the IVR prompt. The inbound route configured here
match DID number 9999, users from NeoGate TA3200 should dial 9999 to reach
Trixbox.
To Next Page
Loading...
Need help?
General
