Installation_Guide | 1 - Installation Guide | 20
Desktop Installation
Caution:
• Set 5~10cm gaps around the device for air circulation.
• Avoid any heavy thing placed on the device.
1. Place the PBX on a steady platform.
2. Remove the adhesive backing paper from the rubber feet.
3. Turn over the device and attach the supplied rubber feet to the recessed areas on the bottom at each corner
of the device.
Install Yeastar S50
Install Telephony Module
Yeastar S50 supports up to 4 modules. The optional modules are as below:
• S2 Module • O2 Module • B2 Module • SO Module
• GSM Module • 3G Module • 4G Module
Note: Before installing the module, check if the module is clean and intact.
To Next Page
Loading...
Need help?
General
