Need help?Do you have a question about the Yeswelder TIG-205DS and is the answer not in the manual?
General| Input Voltage | 110V/220V |
|---|---|
| Output Current Range | 10A-205A |
| Duty Cycle | 60% at 205A |
| Open Circuit Voltage | 65V |
| Efficiency | 85% |
| Power Factor | 0.93 |
| Insulation Class | F |
| Protection Class | IP21S |
| Welding Process | TIG, Stick (MMA) |
Explains the concept of duty cycle and its importance for welder longevity.
Guidelines for preparing the workpiece and setting up the welding area.
Instructions for assembling the TIG welding torch components.
Guide on how to properly sharpen the tungsten electrode for TIG welding.
Instructions for connecting the grounding clamp and TIG torch to the welder.
Guide for connecting the optional foot pedal for arc control.
A procedure to test the quality of a weld by striking it with a hammer.
Discusses causes and solutions for welds not adhering properly in stick welding.
Addresses problems with bending at the joint in stick welds and their causes.
Explains slag removal and common causes of porosity in stick welds.
Discusses crooked beads, wavy beads, and excessive spatter in stick welding.
Details causes and solutions for burn-through in stick welding.
Procedures for periodic cleaning and storage of the welding equipment.
Lists common problems, possible causes, and likely solutions for the welder.
To Next Page
