INSTALLATION
TECHNICAL SPECIFICATIONS: YWM-160
INPUT-SINGLE PHASE ONLY
16V-22V
20 8V-26.4V
10.8v-16.4V
16V-20V
Standard Voltage/Frequency
50/60Hz
110V±100/0 50/60Hz
Input Current
II max=29A, II ett=22.5A
II max=42A, II etf232.5A
Volts at Rated
Current
Voltage
220V
1 IOV
Voltage
220V
1 IOV
RATED OUTPUT-DC ONLY
Mode Duty Cycle
160A
GMAW
124A
100%
60% 160A
SMAW
100% 124A
60%
160A
GTAW
124A
100%
120A
GMAW
93A
1000/0
120A
SMAW
1000/0 93A
120A
GTAW
1000/0 93A
OUTPUTRANGE
OpenCircuit Welding
Current
22V
20.2V
26.4V
24 9V
16.4V
14 9V
20V
18.5V
24.8V
23.7V
14.8V
13.7V
Welding
Mode
GMAW
SMAW
GTAW
GMAW
SMAW
GTAW
voltage Current Range Voltage Range
40A-160A
20A-160A
20A-160A
60V
40A-120A
20A-120A
20A-120A
20 8V
1 0_8V
-24 8V
-148V
OTHER PARAMETERS
Machlne Power Factor Efficiency Protection Class
0.82
2840/0YWM-160
IP21S
PACKING DIMENSIONS
Machine Length Width Height
YWM-160 520mm 295mm 390mm
TEMPERATURE RANGE
nsulat10n Clas
Weight
11.5Kg
Operating Temperature Range Storage Temperature Range
-206C - +50dC(-40F-122ØF) -20'C - +50ØC(-40F-1220F)
Read the entire installation section before you start
the installation.
INSTALLATION
WARNIG
ELECTRIC SHOCK can kill.
• Only qualified personnel should per-
form this installation.
• Only personnel reading and under-
standing the YWM-160 Operator's Man-
ual should install and operate this
equipment.
• The machine must be plugged into a grounded receptacle
per national, local, or other applicable electrical codes.
• The YWM-160 power switch should be in the po-
sition when installing the work cable and gun and con-
necting the power cord to input power.
SELECT SUITABLE LOCATION
Locate the YWM-160 in a dry place with free clean air circula
tion to minimize the chance of dirt accumulation that can block
air passages and cause overheating.
STACKING
YWM-160 cannot be stacked.
TILTING
The machine should be placed on a secure, level surface or a
recommended cart. The equipment may topple Over if this re-
quirement is not followed.
-5
To Next Page
Loading...
Need help?
General
