Assembly
ASSEMBLY
TOOLS NEEDED
Warning: Service on Yeti bicycles requires special
knowledge and tools. Yeti Cycles recommends that all
service and repairs be performed by an authorized Yeti
Dealer
Dead blow hammer
Adjustable pliers
Two - 5mm allen keys
6mm allen key
4mm allen key
4mm t-handle allen key
8mm allen key or 5/16 guide
Linkage tool
TIME
30-45 minutes depending
on condition of the bike
YETI TIPS
Make sure your tools are in good condition.
A worn allen key round the hex on a bolt not
allowing for proper torque.
Torque settings are listed throughout the
instructions. It is also import to prep all bolt
threads . The instruction denote wether to use a
blue Loctite compound or grease.
The linkage tool is necessary to properly
disassemble and reassemble the linkage. Using
a hammer to tap out the pin can cause damage
to the linkage and shock.
Not every too may be needed for the assembly/
disassembly of your bike. The list encompasses
all the tools necessary to complete assembly/
disassembly on each bike
To Next Page
Loading...
