ASR | OWNER’S MANUAL
10
Press both upper bearings into the link using a 10x19mm arbor. Support space between the tabs
on the link while pressing bearings to ensure the link does not bend or get damaged.
Clean outer bearing race with alcohol and apply bearing retaining compound (Green 609 Loctite)
to both lower bearings.
Press both lower bearings into the link using a 10x19mm arbor.
Press one bearing at a time using a 12x24mm arbor
NOTE : Use caution when contacting the inside carbon face to avoid any damage to the
paint. It is not advisable to press both bearings in at the same time.
BEARING PRESS ASSEMBLY
02
01 01
03
03
02
01
01
01
LINK BEARING PRESS MAIN PIVOT BEARING PRESS
To Next Page
Loading...
