12. 13.
KEEP YOUR YETI FRESH
AND CLEAN
OVERVIEW
TORQUE
KEY TORQUE SPECS
Following these guidelines will help maintain the performance of your bicycle and prevent
more serious problems from arising. It is important to remember that service intervals can vary
depending on climate, trail conditions and riding frequency. If you are unsure about working on
your own bicycle, contact your authorized Yeti Dealer for more information on general bicycle
maintenance.
Yeti strongly recommends using a torque wrench when assembling your frame. Torque
specications for individual parts on the SB5 are listed below, as well as in the step by step
assembly instructions later in the manual. For general bicycle maintenance please consult the
torque specications of the component you are adjusting.
PART NUMBER DESCRIPTION TORQUE (NM)
300030151 BOLT TI MALE (M6 X 1 X 12MM) 7
300030057 INFINITY LINK BOLTS (M6 X 1) 12
300040484 UPPER LINK COLLET AXLE (M10 X 10) 3
300040486 UPPER LINK COLLET WEDGE (M5 X .8) 8
300040483 LOWER LINK COLLET AXLE (M10 X 10) 3
300040486 LOWER LINK COLLET WEDGE (M5 X .8) 8
300040485 MAIN PIVOT COLLET AXLE (M15 X 1.5) 3.5
300040454 MAIN PIVOT COLLET WEDGE (M8 X 1.25) 14
WEEKLY
MONTHLY
3 MONTHS
ANNUALLY
CLEAN AND LUBE CHAIN
CHECK TIRE PRESSURE
CLEAN BIKE OF MUD AND DEBRIS
CHECK BRAKE FUNCTION
CHECK SHOCK PRESSURE
CHECK FOR LOOSE BOLTS AND TIGHTEN, IF NECESSARY
CHECK HEADSET AND TIGHTEN / LOOSEN, IF NECESSARY
THOROUGHLY CLEAN PIVOT POINTS WITH A RAG (DO NOT LUBRICATE)
LUBE INFINITY LINK EVERY 40 HRS. (YETI HEAVY MOLYBDENUM GREASE)
CHECK / REPLACE BRAKE PADS
CHECK TIRES FOR WEAR
CHECK SPOKE TENSION. RETENTION, IF NECESSARY
CHECK CHAIN FOR WEAR. REPLACE IF NECESSARY
COMPLETE TUNE-UP PERFORMED BY AN AUTHORIZED YETI DEALER
SCHEDULE
To Next Page
Loading...
Need help?
General
