1 2
Using this machine, the following basic measures to abide by, in order to
avoid electric shock or cause harm to human body.
1. In order to ensure the personal safety, the machine work has been
completed, please close the total power switch to the machine, not use
for a long time please unplug the power cord!
2. You must use the original approved or recommended by parts, otherwise
will lead to serious consequences.
3. Machine failure must be by professionals or the company designated
personnel for repair.
4. This product use three-wire grounding plug, grounding must be inserted
into the three hole socket, don’t change the plug or make with three head
off ground adapter and make bad earth.
5. Please make sure that in the safe state, the machine open, and do not
leave work.
6. Do not use the machine near flammable, explosive gas, objects!!
7. After machine open, its temperature can reach 400 degrees above, do not
touch the preheating plate near the chassis, aluminum mesh.
8. Do not touch the air pressure gun metal parts, heat gun nozzle and jet of
hot air is very hot, don't treat the heat directly spray to the body, is in
danger of burn the body. (853 AA/AAA)
9. Please keep the air pressure gun inlet/outlet flow, there can be no
blockages. (853AA/AAA)
10. Do not touch the iron metal parts, high temperature dangerous! (853AAA)
11. Do not use the soldering iron welding outside of work; Don’t do the
soldering iron percussion work surface to remove fluxes residual, a move
that could seriously damage the iron. (853AAA)
12. When the replacement parts must pull the plug, and cool to room
temperature rear can be carried out.
13. Please put back to handle the heat gun handle frame, machine into sleep
again after power off. (853 AA/AAA)
14. Welding will emit smoke, please get proper ventilation.
15. After use, remember to cooling the fuselage,
WARNING!
I. General Usage
1. Suitable for de-soldering and soldering BGA, SOIC, CHIP, QFP, PLCC packa-
ge SMD IC, particularly suitable for de-soldering BGA module, computer mo-
ther board north and south bridge, all kind of mobile phone motherboard SMT
IC and LED lights.
2. Shrinking, paint drying, adhesive removal, thawing, warming, plastic welding
etc.
II. Feature
1. If the supply cord is damaged, it must be replaced by a special cord or
assemble available from the manufacturer or its service agent.
2. WARNING: This tool must be placed on its stand when not in use.
3. --Be careful when using the appliance in places where there are
combustible materials;
--Do not apply to the same place for a long time.
4. --Be aware that heat may be conducted to combustible materials that
are out of sight;
--Do not leave the appliance unattended when it is switched on.
5. --This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge. Unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
--Children should be supervised to ensure that they do not play with the
appliance.
1. Using microcomputer processor PID programmable temperature control techn-
ology, the program cycle every 20 milliseconds to detect the actual temperature
of the heating element and a quick correction, rapid return temperature, tempe-
rature stability LED display, precise preheating station, air gun and soldering
iron temperature.
2. Preheating station is to use a glaze layer having a high thermal effect, good the-
rmal shock resistance of the ceramic as the substrate, high-quality nickel brand-
ed alloy wire once sintering. It has a high thermal effect, overall good, good the-
rmal stability, uniform heating, high dielectric strength, clean, easy to install and
so on features.
To Next Page
Loading...
