C O N T E N T S
ENGLISH
EC Declaration of Conformity 3
Technical Features 4
Cutting Diagram 5
Dimensions 6 & 9
Part List 10 & 14
Spare Part List 15
1. General Information 73
1.1 Introduction 73
1.2 Service Information 73
2. Safety 74 & 76
2.1 Safety Symbols and Their Meanings 74
2.2 Accidents Prevention 74
2.3 General Safety Information 75
2.4 Safety Of The Personnel Operatıng The Machine 76
2.5 Personal Protectıve Equıpments 76
2.6 Procedure For Isolation Of Machine 76
3. Machine’s Description 77 & 79
3.1 DC 550 M Semi Automatic Double Head Cutting Machine 77
3.2 DC 550 PB Automatic Double Head Cutting Machine ( Computer Controlled ) 78
3.3 DC 550 SK Automatic Double Head Cutting Machine ( Servo System-Computer Controlled ) 78
4. Transport of the Machine 79
5. Installation of the Machine 80
5.1 Preparation 80
5.2 Connecting to Power Source 80
6. Machine’s Safety Information 81
7. Operation 82 & 117
7.1 Preparation 82
7.2 DC 550 M Operational Information 83-84
7.3 Display Counter Reset 85-86
7.4 Changing Display Parameters 87
7.5 Calibration of Display 87
7.6 Changing the Initial Values 87
7.7 Replacing the Battery on the Display 88
7.8 DC 550 Operational Information 89-110
7.9 DC 550 Series Cutting Modes 111-117
8. Profile Height Measuring Device
118-119
9. PLC Software Update
120
10. Solving the Screen Errors
121
11. Maintenance, Service and Repair
122-125
11.1 Maintenance 123
11.2 Changing the Cutting Tool 123
11.3 Changing the Belt 124
11.4 Adjust the Air Pressure 125
12. Noise Emission Values
126
13. Troubleshooting Guide
127
14. Warranty Conditions
128
To Next Page
