User’s
Manual
Contents
1. Introduction
1.1 For Safe Use of Product ................................................3
1.2 Warranty .........................................................................6
1.3 Combination for Remote Sensor and Remote
Transmitter .....................................................................6
2. Receiving and Storage
2.1 Model and Speci cations Check ...................................7
2.2 Storage Precautions ......................................................8
3. Installation
3.1 Piping Design Precautions ............................................9
3.2 Handling Precautions ...................................................11
3.2.1 General Precautions .......................................11
3.2.2 Flowmeter Piping ........................................... 12
3.3 Integral Flowmeter and Remote Sensor Installation .. 13
3.3.1 Size 25 to 200 mm (1 to 8 in.),
Wafer Type .................................................... 13
3.3.2 Size 25 to 400 mm (1 to 16 in.),
Flange Type ................................................... 18
3.3.3 Gasket Size(customer pipe) .......................... 24
3.4 Remote Transmitter Installation .................................. 25
3.4.1 Installation Location ....................................... 25
3.4.2 Mounting of AXW4A Transmitter ................... 25
3.4.3 Mounting of AXG1A Transmitter .................... 25
3.4.4 Mounting of AXFA11 Transmitter ................... 26
3.5 Changing Direction of Cable Entry ............................. 26
3.6 Changing Direction of Display Unit ............................. 27
4. Wiring
4.1 Wiring Precautions ...................................................... 29
4.2 Cables ......................................................................... 30
4.3 Cable Entries .............................................................. 31
4.4 Connecting to External Products of Integral
Flowmeter and Remote Transmitter ........................... 35
4.5 Connecting to Remote Sensor and Remote
Transmitter (Sensor Side) ........................................... 42
4.6 Input and Output ......................................................... 45
5. Basic Operating Procedures
5.1 Operation by Display unit ............................................ 48
5.2 Display and Basic Con guration ................................. 48
5.3 Display Mode and Setting Mode ................................. 51
5.4 Parameter Setting from Display Panel ....................... 52
5.5 microSD Card Setting ................................................. 53
5.6 BRAIN Con guration Tool ........................................... 54
5.7 HART Con guration Tool ............................................ 54
5.8 Modbus Con guration Tool ......................................... 55
5.9 FOUNDATION eldbus Con guration Tool ..................... 56
6. Operation
6.1 Pre-operation Zero Adjustment ................................... 57
6.2 Zero Adjustment from Display Unit ............................. 57
6.3 Hardware Switch Setting ............................................ 58
7. Errors and Countermeasures (Display unit)
1
2
3
4
5
6
7
ADMAG TI Series
AXW Magnetic Flowmeter
[Size: 25 to 400 mm (1 to 16 in.)]
Installation Manual
IM 01E24A01-01EN
IM 01E24A01-01EN
4th Edition
Integral Flowmeter
(AXW###)
Remote Transmitter
(AXW4A)
Remote Sensor
(AXW###)
Remote Transmitter
(AXG1A)
Remote Transmitter
(AXFA11G)
This manual outlines the basic guidelines for installation and
wiring procedures. For the items which are not covered in this
manual, read the user’s manuals and the general speci ca-
tions as listed in Table 1.1.
For explosion protection type, also read the applicable user’s
manual as listed in Table 1.1.
To Next Page
Need help?
General
