YOKOGAWA SMARTDAC+ GP10 - Page 20

12
IM 04L51B01-18EN
Explicit Message
Datatobeaccessed Filenumber
Type Number Datatype
INT16
Datatype
INT32
Datatype
FLOAT
Input/Output channel
(Continuous channel data
area)*
0001 N45:00 L45:00 F45:00
• • • • • • • • • • • •
0010 N45:09 L45:09 F45:09
0101 N45:10 L45:10 F45:10
• • • • • • • • • • • •
0110 N45:19 L45:19 F45:19
0201 N45:20 L45:20 F45:20
• • • • • • • • • • • •
0210 N45:29 L45:29 F45:29
0301 N45:30 L45:30 F45:30
• • • • • • • • • • • •
0310 N45:39 L45:39 F45:39
0401 N45:40 L45:40 F45:40
• • • • • • • • • • • •
0410 N45:49 L45:49 F45:49
0501 N45:50 L45:50 F45:50
• • • • • • • • • • • •
0510 N45:59 L45:59 F45:59
0601 N45:60 L45:60 F45:60
• • • • • • • • • • • •
0610 N45:69 L45:69 F45:69
0701 N45:70 L45:70 F45:70
• • • • • • • • • • • •
0710 N45:79 L45:79 F45:79
0801 N45:80 L45:80 F45:80
• • • • • • • • • • • •
0810 N45:89 L45:89 F45:89
0901 N45:90 L45:90 F45:90
• • • • • • • • • • • •
0910 N45:99 L45:99 F45:99
Computation channel A001 N50:00 L50:00 F50:00
• • • • • • • • • • • •
A200 N51:99 L51:99 F51:99
Communication channel
(Read/Write)
C001 N60:00 L60:00 F60:00
• • • • • • • • • • • •
C500 N64:99 L64:99 F64:99
Specify a data address, for example, as N10:0 (where N is INT16, the file number is 10, and the
element number is 0).
Use only N file for command, “PLC5 Word Range Read/Write”
“• • •” stands for data in numerical order.
* The “continuous channel data area” is a special area that enables continuous reading by limiting
the number of channels of each module to 10.
For only the I/O channels on a GX/GP main unit or I/O channels on a GM main unit, this area
can be used to read data consecutively.