EasyManuals Logo

YOKOGAWA UP150 Instruction Manual

YOKOGAWA UP150
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
IM 5E1E70-01E
26
(3) If the segment consists of an ascending gradient (ramp) only:
The starting point of program-driven operation is any of points A (SSP) to E.
PV
1
2
3
4
5
C
D
Note (see below table)
B
A(SSP)
Seg.1 Seg.2
Time
Example Where the Segment Consists of an Ascending Gradient (Ramp) Only
The starting point of program-driven operation is determined by where the measured input value (PV) is
located at the time the operation starts.
Starting point of program-
driven operation
Measured input value (PV) at startup of
program-driven operation
Program-driven operation does not start up.
*1
D
C
B
A (SSP)
1
2
3
4
5
*1: Program-driven operation does not start up, “JC” at the end of operation also does not work.

Other manuals for YOKOGAWA UP150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YOKOGAWA UP150 and is the answer not in the manual?

YOKOGAWA UP150 Specifications

General IconGeneral
BrandYOKOGAWA
ModelUP150
CategoryTemperature Controller
LanguageEnglish

Related product manuals