<Toc> <Rev>
i
IM 05D01D02-41E
Introduction
Thank you for purchasing the UT350/UT320 digital indicating controller.
■ How to Use the Manuals
Purpose Description
Setup Describes the tasks (installation, wiring, and others) required
to make the controller ready for operations.
Basic operation
Describes examples of setting PV input types, control output
types, and alarm types. Making settings described herein
allows you to carry out basic control.
Operating procedures
and troubleshooting
Describes key operation sequences.
For operation control through external contact inputs, see
“1.5 Terminal Wiring Diagrams.”
Brief operation
and setpoint recording
Contains the parameter map used as a guideline for setting
parameters and lists of parameters for recording User Settings.
Title
1. Installation
2.
Initial Settings
3. Operations
4.1 Troubleshooting
5. Parameters
■ Regarding This User’s Manual
(1) This manual should be provided to the end user. Keep an extra copy or copies of the
manual in a safe place.
(2) Read this manual carefully to gain a thorough understanding of how to operate this
product before starting operation.
(3) This manual describes the functions of this product. Yokogawa M&C Corporation
(hereinafter simply referred to as Yokogawa) does not guarantee the application of
these functions for any particular purpose.
(4) Under absolutely no circumstances may the contents of this manual, in part or in
whole, be transcribed or copied without permission.
(5) The contents of this manual are subject to change without prior notice.
(6) Every effort has been made to ensure that the details of this manual are accurate.
However, should any errors be found or important information be omitted, please
contact your nearest Yokogawa representative or our sales office.
1st Edition : May 31,2000-00Media No. IM 05D01D02-41E (CD) 1st Edition : May 2000 (YK)
All Rights Reserved Copyright © 2000, Yokogawa M&C Corporation
To Next Page
Loading...
Need help?
General
