10
9.4.1 Set up: Send SMS message to the unit, it will report the Geo-info at 30s intervals
for 5 times.(s: second, m: minute, h: hour).You will receive a reply as “t030s005n OK” if
the setting is successful. The setting must be in 3 digits and at maximum 255 in value.
9.4.2 Send SMS message to the unit, it will reply SMS heaps of times. You will receive a
reply as the setting is successful.
9.4.3 Cancel: Send message to delete the “ auto track “.
Remark: the interval must not be less than 30s.
9.5 Geo-fence
Set up a geo-fence for the unit to restrict its movement within a district. The unit will
send message to the authorized numbers when it moves out of this district.
Notes: This function will be invalid if the unit moves outside the district. You need to
re-set it if you want this function again.
9.5.1 Setup:Send SMS message to the unit to set the restricted district.
Remark :The first latitude&longitude is coordinate of the top left corner of the Geo-fence,
while the second latitude&longitude is the coordinate of the bottom right corner.
9.5.2 Cancel:Send SMS message to deactivate this function..
9.5.3 Response SMS format: stockade!+geo-info. It will alarm one time in each setting.
9.6
Movement
Alert
This function is using for the owner to get alarm when the tracker moves out of a
restricted district.
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page