SHOULD YOU REQUIRE ANY ASSISTANCE REGARDING THIS PRODUCT PLEASE CONTACT YORK DIRECTLY.
*
*
WE RECOMMEND YOU HAVE SOMEONE ASSIST YOU IN LIFTING AND
ASSEMBLING YOUR PACER 3503 TREADMILL.
FOLLOW THESE INSTRUCTIONS CAREFULLY AND IT WILL MAKE IT EASIER
FOR YOU TO ASSEMBLE YOUR PACER 3503 TREADMILL.
GENERAL
ASSEMBLY INSTRUCTIONS
1.
Ask someone to help you remove all the parts and packaging materials on the top of your
PACER 3503 from the carton and place them on the floor carefully.
Rest the left handle bar post, with the locking device
fitted, beside the main frame and close to the handle
bar mounting tube carefully as shown.
Connect the sensor wire socket to the middle
wire plug protruding at the base of the left
handle bar post.
NOTE: TAKE CARE to ensure the wires are connected
as tightly as possible.
NOTE TAKE CARE
Product may vary slightly from the item pictured.
2.
BASE
CARTON
MAIN
FRAME
Fold the main frame up and stand it in the base carton
as shown.
Ask someone to help you hold the treadmill on each
side and lift it out from the base carton carefully.
3.
LEFT HANDLE
BAR POST
SENSOR
WIRE SOCKET
2.
1.
PACER 3503 / 3
MIDDLE
WIRE
PLUG
LOCKING
DEVICE
To Next Page
Loading...
