York Solution - Disassembly - Unit Side and End Panels; Remove End and Side Panels

YORK INTERNATIONAL
12
FORM 102.20-FA1 (1104)
12. REMOVE END PANEL(S)
13. REMOVE SIDE PANEL(S)
a) Remove rubber grommets from around coil
connectors prior to removing panels.
FIG. 13 - REMOVE BOTTOM FRONT END PANEL(S)
FIG. 14 - REMOVE LOWER BACK END PANEL(S)
FIG. 15 - REMOVE GROMMET(S)
b) Remove side panel(s) from right side.
c) Remove side panel(s) from left side.