York TIWM018B21S - Page 37

P5417052
33
TIWM015B21StoTIWM030B21S
(1) Hold both ends of the at panel and lift up.
Open and fully extend the at panel and push the right arm shaft inward. After the shaft is separated
from the front panel, pull the at panel forward with the right arm shaft slightly pushed inward and
remove the at panel. Remove the lower right corner cover panel by pressing inward against both
ends.
Remove this part
from the hole.
Push the shaft
in the direction
of the arrow.
Front Panel
Lower Right Corner Cover
Flat Panel
Press
Press to
remove
(2) Remove the three (3) screw caps and three (3) screws as shown. Pull the lower side of the front panel
(2 portions) forward to release the catch-ttings. Use a slotted screwdriver if the catch-ttings prove
difcult to release. Be careful not to make contact with the air outlet louver, as the louver edges can be
easily damaged.
Screw
Holes for Catch-Fitting
Screw Cap
Catch-Fittings for
Lower Side of Front Panel
When using a slotted
screwdriver, insert it
into the gap and push
the catch-fittings downwards.
Condensate Pan Fitting
(3) Slightly lift the front panel up to release the catch-ttings at four locations on the upper side of the unit.
Then pull the front panel forward to remove it.
(4) Remove the screw securing the electrical box cover and open it.
Switch Cover
Electrical Box
Cover
Remove this screw
Unit
Electrical Box Cover
Switch Cover