Step 6. Install the armrest and electronic watch
Required accessories: armrest (2), electronic watch (53), flat pad (87), L-shaped quick release (89),
battery (93).
(please refer to the figure below)
The handrail (2) is fixed on the handrail adjusting pipe (3) and is tightly fixed by a flat pad (87) and an
L-shaped quick release. After the hand is fixed, the battery (93) is inserted into the electronic watch
(53) and then inserted into the armrest fixing piece, the visual angle of the electronic watch is adjusted,
the spring wire left on the vehicle body is inserted into the hole position of the electronic watch, and
then the heart rate wire on the armrest is inserted into the hole position of the electronic watch.
To Next Page
Loading...
