Step 7. Install the IPAD holder
Required accessories: IPAD holder (10), umbrella head cross screw (88)2, spring pad (73)2,
multifunctional spanner (92). (please refer to the figure below)
Take out the IPAD holder (10) and fix it to the armrest with the umbrella head cross screw (88) and
the spring pad (73) with the multi-function wrench (92).
Please note that all bolts must be uniformly locked after confirming that all the bolts have been
installed in accordance with the above requirements, and can only be used after checking that
there are no omissions.
To Next Page
Loading...
