YSOFT SAFEQ USB CARD READER V2 – ADMINISTRATOR’S GUIDE V1.2 [EN] 20/22
5 INFORMATION BEEP COD ES
Here is the list of beep codes, which give the result on the behavior of USB reader v2.
Legend:
- Long beep sound
. Short beep sound
- Card read error. Please try placing the card again or use the different card.
...- Hardware configuration damaged cannot continue in booting.
.-.- Update of firmware failed.
--.- Software configuration cannot be saved. Probably faulty onboard eeprom.
..-- Software configuration damaged, loading defaults.
.--- Firmware damaged.
-... No reader connected and reader required for correct functionality.
-.-. Service firmware damaged, re restore required.
.--. Error in reader power-up sequence
Note: This option is available only if sound is enabled.
To Next Page
Loading...