Yudian AI-518P - Rear Terminal Layout and Wiring Diagrams

13
1.5 Rear Terminal Layout and Wiring
Wiring graph for instruments except D and D2 dimension.
Note 1: For linear voltage input, if the range is
below 500mV, connect to terminals 19 and 18.
0～5V or 1～5V signal can be inputted from
terminals 17 and 18.
Note 2: 4～20mA linear current signal can
change to 1～5V voltage signal by connecting
a 250 ohm resistor, and then be inputted from
terminals 17 and 18. If I4 module is installed
in MIO slot, 4～20mA signal can be inputted
from terminals 14+ and 15-, and 2-wi re
transmitter can be inputted from terminals 16+
and 14-.
Note 3: The compensation wires for different
kinds of thermocouple are different, and
The graph suits for upright instruments
with dimension A or E
For instruments with dimension F,
just clockwise rotate the graph 90
degree, and the numbers of the
terminals keep the same.
AU1
M2/MIO
AUX
ALM
COMM
AL2
1
2
3
4
5
6
7
8
9
10
11
12
15
16
17
18
19
20
13
14
AL1
AU2
COM
COM
N/O
N/C
N/O
N/O
+
+
A
B
+
100-240VAC~
+
+
OUTP
COM
COM
N/O
N/C
N/O
N/O
COM
COM
N/O
N/O
N/O
N/C
+
+
OP2
OP1
+
0-5V
1-5V
G1
G2
G1
G2
G1
G2
Thyristor trigger output
（
K1/K3
）
Thyristor trigger output
（
K3
）
Thyristor trigger outuput
（
K3
）
+
COM
N/C
V+
N/O
+
+
+