Z-Wave QUBINO FLUSH SHUTTER - Associations

EN.
37
12. Associations
Use associations for direct communication between the Flush Shutter and other devices within
your Z-Wave network without the need of your primary gateway (hub).
Association Groups:
Root device:
• Group 1: Lifeline group (reserved for communication with the primary controller), 1
node allowed.
• Group 2: Basic on/off (status change report for I1 input) up to 16 nodes.
• Group 3: Basic on/off (status change report for I2 input) up to 16 nodes.
• Group 4: Basic on/off (status change report for sensing roller moving: up=FF, down=0)
up to 16 nodes.
• Group 5: Basic on/off (status change report at reaching roller position: bottom=FF,
top=0) up to 16 nodes.
• Group 6: Basic on/off (status change report at reaching roller position: bottom=FF, not
bottom=0) up to 16 nodes
• Group 7: Multilevel set (status change report for Flush Shutter position), up to 16 nodes.
• Group 8: Multilevel sensor report (external temperature sensor report – sensor sold
separately), up to 16 nodes.
End point 1:
• Group 1: Lifeline group, 0 nodes allowed.
• Group 2: Basic on/off (status change report for I1 input), up to 16 nodes.
• Group 3: Basic on/off report (status change report for I2 input), up to 16 nodes.
• Group 4: Basic on/off (status change report for sensing roller moving: up=FF, down=0)
up to 16 nodes.
• Group 5: Basic on/off (status change report at reaching roller position: bottom=FF,
top=0) up to 16 nodes.
• Group 6: Basic on/off (status change report at reaching roller position: bottom=FF, not
bottom=0) up to 16 nodes
• Group 7: Multilevel set (status change report for Flush Shutter position), up to 16 nodes.
End point 2:
• Group 1: Lifeline group, 0 nodes allowed.
• Group 2: Multilevel set (status change report slats tilting position), up to 16 nodes.