EN.
35
10. Adding the device to a Z-Wave network (Inclusion)
AUTOMATICALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (AUTO INCLUSION)
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected –
sold separately*).
3. Auto-inclusion will be initiated within 5 seconds of connection to the power supply and the
device will automatically enroll in your network
MANUALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (MANUAL INCLUSION)
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected*)
3. Toggle the switch connected to the I1 terminal 3 times within 3 seconds
OR
If the device is powered by 24 V SELV supply, press and hold the S (Service) button for at least 2
seconds
4. A new multi-channel device will appear on your dashboard
*If connecting the temperature sensor, switch off the power supply and make sure the device
is excluded from your network BEFORE connecting the sensor.
ⓘ Make sure the device is excluded from your network before connecting the temperature
sensor. Switch off the power supply, connect the temperature sensor, and re-include the device
to your network.
To Next Page
Loading...
Need help?
General
