Need help?Do you have a question about the Z-Wave QUBINO FLUSH SHUTTER and is the answer not in the manual?
General| Overcurrent protection | Yes |
|---|---|
| Z-Wave Plus | Yes |
| Protection Class | IP20 |
| Z-Wave Frequency | 868.42 MHz |
| Rated Load Current | 4A (230VAC) / 4A (115VAC) |
| Compatibility | Z-Wave |
| Range | Up to 30m indoors |
| Product Type | Shutter Control |
| Compatible Motors | AC motors |
| Associations | Up to 5 associated devices |
| Firmware Update | OTA (Over the Air) |
| Operating Temperature | -10°C to +40°C |
Step-by-step instructions for installing the Flush Shutter module behind a standard wall switch.
Guides the user on how to integrate the installed device into their existing Z-Wave network.
Detailed instructions for connecting and installing the optional external temperature sensor.
Details the automatic method for including the device into the Z-Wave network.
Details the manual method for including the device into the Z-Wave network.
Describes the procedure for performing a factory reset on the device to restore default settings.
Details methods for calibrating the physical movement limits of the shutter.
Specific calibration for venetian blinds to set slat position and angle.
Configures the activation and deactivation of the ALL ON/ALL OFF functionality.
Selects between Shutter mode and Venetian blinds mode for operation.
Initiates the shutter calibration process to learn limit switch positions.
Important notes regarding Z-Wave reliability and device recognition by gateways.
Environmental warning regarding the disposal of electrical appliances and hazardous substances.
FCC compliance statement detailing device regulations and radio frequency interference guidelines.
To Next Page
