EN.
27
7.2. Installing the Qubino Temperature Sensor
The temperature sensor is a Qubino accessory and is sold separately - for more info, please
see the Qubino product catalogue or website: http://qubino.com/products/accessories/
Product ordering code: ZMNHEA1
Qubino Z-Wave modules have the option to connect a temperature sensor (sold separately),
which allows you to remotely monitor ambient or water temperature. Qubino modules are the
only Z-Wave devices of its kind to offer this unique capability. With the sensor connected to the
module, you can carry out accurate measurements of room temperature, pool water
temperature, etc. and build automation rules around them. Qubino module with a temperature
sensor is connected directly to power supply. Install it and forget it, there is no need to worry
about changing the batteries like with most other Z-Wave temperature sensors which run on
batteries. The temperature sensor’s range is between -50° and 125°C (-58° - 257° F).
The digital Temperature sensor comes with a 1 m (3.3 ft) cord and a connector to attach it
directly to a Qubino module.
1. To prevent electrical shock, make sure that no voltage is present on the temperature
sensor cable.
2. When connected to Qubino module, the temperature sensor is under high voltage,
which is very dangerous.
3. Goap d.o.o. does not take responsibility for any damage or electrical shock due to
incorrect sensor assembly.
4. The above instructions and description apply to a temperature sensor compatible with
Qubino products only.
To Next Page
Loading...
Need help?
General
