34
Press SET key to confirm the set value or wait 15 seconds, Now the unit is operating and does not require any
further programming. The refrigerating cycle is fully automatic according to the factory-set parameters, which can
be modified by authorised personnel only.
ATTENTION
24 hours after starting check evaporator state. If ice has formed, defrost frequency should
be increased. In low temperature units the evaporator condition should be checked every
week during the first month of operation.
9.2
Quicly guide to installation
1) Install the air flow conveyor
2)To install, unscrew the nuts from the holes corresponding to the ones on the conveyor and screw back (see
following pictures)
To Next Page
Loading...
