What to do if my Zanussi Cookers won't activate?
If your appliance won't activate, it could be due to a couple of reasons: * The appliance might not be correctly connected to the electrical supply. Check the connection. * The fuse may be blown. If this is the case, and it continues to blow, contact a qualified electrician.
What to do if my Zanussi ZCI66250BA Cookers oven does not heat up?
If the oven does not heat up, ensure that it is activated. Also, check that the clock is set and all necessary settings are correctly configured.
Why Zanussi ZCI66250BA display shows "12.00"?
The display shows "12.00" because there was a power cut. Reset the clock to resolve this.
What to do if my Zanussi Cookers hob won't activate or operate?
If you cannot activate or operate the hob, it may be because you are touching two or more sensor fields at the same time, so touch only one sensor field. Another reason could be water or fat stains on the control panel, so ensure the control panel is clean.
Why Zanussi ZCI66250BA Cookers sensor fields become hot?
The sensor fields may become hot if the cookware is too large or placed too near the controls. If possible, put large cookware on the rear zones.
Why Zanussi ZCI66250BA Cookers hob deactivates and acoustic signal sounds?
If an acoustic signal sounds and the hob deactivates, or if an acoustic signal sounds when the hob is deactivated, it is probably because you have put something on one or more of the sensor fields. Remove the object from the sensor fields.
Why steam settle in the Zanussi ZCI66250BA oven?
Steam and condensation may settle on the food and in the oven if you leave the dish in the oven for too long after cooking. To avoid this, do not leave the dishes in the oven for longer than 15 - 20 minutes after the cooking process ends.
How to fix Zanussi ZCI66250BA lamp if it does not operate?
If the lamp does not operate, it is likely defective and needs to be replaced.
What to do if there is no signal when you touch Zanussi Cookers panel sensor fields?
If there is no signal when you touch the panel sensor fields, the signals are likely deactivated. You can activate them by referring to the "Hob - Daily use" chapter.
Why Zanussi Cookers residual heat indicator does not come on?
The residual heat indicator may not come on if the zone is not hot because it operated only for a short time. If the zone operated sufficiently long to be hot, speak to an Authorised Service Centre.
To Next Page
General
