EasyManuals Logo

Zapi ZAPIMOS H2B User Manual

Zapi ZAPIMOS H2B
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
H2B USER'S MANUAL - 550145G Page 37/60
5.3 H2B TRACTION DIAGNOSIS
Description of the alarms signalled by the diagnostic LED.
The alarm code is shown in parentheses. A detailed description is given in the section
“DECODING THE ALARMS DISPLAYED ON CONSOLE” on point 5.5.
1 BLINK = Logic anomaly (EEPROM DATA KO, EEPROM PAR. KO,
EEPROM CONF. KO, EEPROM OFF-LINE, CHOPPER NO CONF,
WATCH-DOG).
2 BLINKS = Running request on startup or error in handle/speeds sequence
(INCORRECT START).
3 BLINKS = Error on VMN test (NO FULL CONDUCTION, VMN LOW).
4 BLINKS = Accelerator high in standby - this error inhibits operation (VACC NOT OK).
5 BLINKS = Error in reading current - this error inhibits operation (I HIGH AT STAND,
I=0 EVER).
6 BLINKS = Malfunctioning of the contactor driver circuit (DRIVER SHORTED,
COIL SHORTED).
7 BLINKS = Excessive temperature, greater than 79°C (TH. PROTECTION).
8 BLINKS = Contactors do not open or VMN high in standby (BRAKE CONT. OPEN,
DIR CONT. OPEN, VMN HIGH).
9 BLINKS = Contact stuck (BRAKE CON CLOSED).
CONTINUOUS BLINKING (32 BLINKS) = Low battery charge, battery with < or =10% of
residual charge (BATTERY).
LED REMAINS ON = Double running request (FORW BACK).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zapi ZAPIMOS H2B and is the answer not in the manual?

Zapi ZAPIMOS H2B Specifications

General IconGeneral
BrandZapi
ModelZAPIMOS H2B
CategoryControl Unit
LanguageEnglish