Zapp Z710i - Basic Operation; To Place a Calls; To Terminate a Call; To Dial the Last Number Received

1514
BASIC OPERA
BASIC OPERA
TION
TION
To Place a Calls
1.
Enter the phone number.
(A maximum of 32 digits will be displayed.)
To Terminate a Call
1.
Press [ ]. The [ ] indicator will go out.
To dial the last number received
1.
Press [ ], [ ], [ ], [ ]keys or [ ],
[ ], [ ].
2.
Press [ ].
The [ ] indicator will light.
• To Correct a Number
Press [ ] to clear the last digit.
Press and hold [ ] to erase all the digits entered.
• If the Call Fails to Go through
Press [ ] and [ ] to redial the number.
Last Number Redial
1.
2.
Press [ ] to recall the last number you dialed.
Press [ ] to redial it.
BASIC OPERA
BASIC OPERA
TION
TION
Speed Dialing
1.
Enter the one or two digits of your Phonebook address
(6 to 9 or 10 to 99).
2.
Press [ ]. The phone number will be displayed.
The [ ] indicator will light, and the call will be placed.
In idle mode, calls be placed to numbers stored in speed dial by pressing its location
number on the keypad.
Emergency Call
This feature permits you to place an emergency call even if your telephone is in “Phone Lock”
mode, Up to 5 numbers can be programmed as Emergency numbers.
Note
If two telephone numbers are stored in the address, the Primary Number will be dialed.
Example
Emergency number in “Phone Lock” mode
1. Enter Emergency number
2. Press [ ].
The [ ] indicator will light, and the call will be placed.