17
Media Rewind Upgrade
Installing the Media Rewind Option Kit
10/23/2006 33181L-001 Rev. A
Reconfigure the Printer for Rewind Operation
1. Enter the Configuration mode by pressing Setup/Exit at the Printer Ready display.
2. Press Next/Save until you get to Print Mode.
3. Press (+) or (–) until you select REWIND.
4. Press Setup/Exit to leave the Configuration mode. Press (+) or (–) to select Permanent.
Press
Next/Save to accept and make permanent.
Adjusting the Platen Support Bracket
If the liner is tracking off to one side, you will need to reposition the roller adjust plate.
To position the roller adjust plate, perform the following procedure:
1. See Figure 11. Loosen, but do not remove, the two screws holding the platen support
bracket to the side plate.
Figure 11 • Platen Support Bracket Adjustment
Lower
Roller
Screws
Side Plate
Platen
Support
Bracket
To Next Page
Loading...
