Zebra DS4208 User Manual

DS4208
1 2 3
7
0
0
9
1 2
3 4
5
http://www.zebra.com/ds4208
STEP 2 -CONNECT CABLE TO A HOST
STEP 1 - ATTACH CABLE TO SCANNER
Quick Start Guide
Scan ONE of the bar codes below
Scan ONE of the bar codes below Scan ONE of the bar codes below
Attach Cable
Remove Cable (to change interface)
STEP 3 - SET UP INTERFACE (Scan Host Bar Codes)
STANDARD RS-232
OPOS/JPOS
IBM AT Notebook
IBM PC/AT and IBM PC COMPATIBLE
HID KEYBOARD EMULATION
Symbol Native API (SNAPI) without Imaging Interface
IBM HAND-HELD USB
Important: Out of box, RS-232 and USB interfaces require no bar code scan setup. Bar codes are provided for complex programming or interface changes.
ADD AN ENTER KEY (CARRIAGE RETURN/LINE FEED)
To add an ENTER key after scanned data, scan all THREE bar codes below in numerical order.
SCAN OPTIONS
<DATA><SUFFIX> ENTER
RS-232 Keyboard Wedge USB
NOTE: Cables may vary depending on configuration.
IBM 46XX
Scan ONE of the bar codes below
Keyboard Wedge
USB
RS-232 IBM 46XX
POST IN WORK AREAPOST IN WORK AREA
To add a Tab key after scanned data, scan all THREE Enter key bar codes above in numerical order then scan all FIVE bar codes below in numerical order.
See Product Reference Guide for detailed information
Note: An audible click sounds when the shielded cable is inserted correctly.
PORT 5B
PORT 9B
ADD A TAB KEY
SCAN SUFFIX

Zebra DS4208 Specifications

General

Type	Handheld bar code reader
Wavelength	617 nm
Sensor type	Laser
Yaw reading angle	-60 - 60 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	Codabar, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128), U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Data Matrix, MaxiCode, MicroPDF417, PDF417, QR Code
Connectivity technology	Wired
Input voltage	5 V
Power consumption	275 mA
Power source type	-
Certification	FCC
Product color	Black
International Protection (IP) code	IP43
Sustainability certificates	RoHS
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Depth	93 mm
Width	68 mm
Height	170 mm
Weight	172.9 g

Summary

STEP 1 - ATTACH CABLE TO SCANNER

STEP 2 - CONNECT CABLE TO A HOST

USB Host Connection

Connecting the scanner to a host computer via USB interface.

Keyboard Wedge Host Connection

Connecting the scanner to a host computer via Keyboard Wedge interface.

RS-232 Host Connection

Connecting the scanner to a host computer via RS-232 serial port.

IBM 46XX Host Connection

Connecting the scanner to an IBM 46XX system.

STEP 3 - SET UP INTERFACE (Scan Host Bar Codes)

USB Interface Setup

Scanning barcodes to configure the USB interface for the scanner.

Keyboard Wedge Interface Setup

Scanning barcodes to configure the Keyboard Wedge interface.

RS-232 Interface Setup

Scanning barcodes to configure the RS-232 interface for the scanner.

IBM 46XX Interface Setup

Scanning barcodes to configure the IBM 46XX interface.

Configure Enter Key

Configure Tab Key