page 4 of 4
Printing a test label
1. Make sure the media is properly loaded and the top cover of the printer is closed.
Then, turn the printer power on if you have not already done so. If the printer
initializes with the status light blinking green (pause mode), press the Feed
button once to set the printer in Ready (to print) mode.
2. When the status light is solid green, press and hold the Feed button until the
status light flashes once.
3. Release the Feed button. A configuration label will print
Resetting the Factory Default Values
Sometimes, resetting the printer to the factory defaults may solve some problems.
Press and hold the Feed button until the green status light flashes 4 times and
release the Feed button.
Turn on the printer; check the power connections
If this error occurs right after you turn on the
printer, contact Choose 2 Rent for assistance.
When the printer is operating normally, the
printer status light will be amber for about 10
seconds before turning green
As soon as all of the data has been received, the
status LED will turn green and the printer will
automatically resume operation
The media is out - insert a new Paper roll and
resume printing
The printhead is open - close the top cover and
press the Feed button to resume operations
Please call our support team if you need assistance setting
up your rental devices - 1(800) 622-6484
To Previous Page
Loading...