Need help?Do you have a question about the Zebra TLP 2844-Z and is the answer not in the manual?
General| Resolution | 203 dpi |
|---|---|
| Media Sensors | Reflective and transmissive |
| Print Method | Direct Thermal |
| Print Width | 4.09 inches |
| Max Print Speed | 4 inches per second |
| Max Print Length | 39 inches |
| Connectivity | USB, Serial, Parallel |
| Media Handling | Roll-fed, Fanfold |
| Label Roll Capacity | 5" (127 mm) O.D. |
| Supported Barcode Types | Code 39, Code 128, UPC, EAN, Interleaved 2 of 5 |
| Supported Media Types | Roll-fed or fanfold, die-cut labels with or without black mark, tag stock, continuous receipt paper, wristbands |
| Media Width | 1.0" (25.4 mm) to 4.25" (108 mm) |
| Media Thickness | 0.003 inches (0.08 mm) to 0.0075 inches (0.19 mm) |
| Operating Temperature | 40°F (5°C) to 105°F (41°C) |
| Storage Temperature | -40°F (-40°C) to 140°F (60°C) |
| Power Requirements | 100-240 VAC, 50-60 Hz |
Addresses issues with no print output, focusing on media compatibility and ribbon sensor function.
Troubleshoots issues with the printed image, including dirt print heads, temperature, and media compatibility.
Diagnoses and resolves blank vertical lines on labels, often due to a dirty or damaged print head.
Addresses problems where ribbon sensor settings do not print correctly, suggesting direct thermal mode issues.
Solves printing issues where labels start incorrectly or have misprints, often related to media threading or calibration.
Troubleshoots situations where the printer does not recognize sent label formats, checking pause mode, status LEDs, and connections.
Instructions to print a configuration label to list the printer's current settings.
Guidance on recalibrating the printer to resolve skipping labels or other unusual symptoms.
Using the feed button while the printer is off to print configuration and enter diagnostics.
Using the feed button while the printer is on to perform calibration, reset defaults, and more.
To Next Page