Zebra TLP 2844-Z User Manual

The printing does not start at the top of the label, or misprinting of
one to three labels.
■
The media may not be threaded under the media guides. Refer to
“Loading the Media” on page 9.
■
The printer needs to be calibrated. Refer to “Auto Calibration” on page
13.
■
The correct media sensor may not be activated. Manual calibration
selects the media sensing method for the labels being used (refer to the
^MN command in the ZPL II Programming Guide).
■
Verify that the Label Top (^LT) command is correctly set for your
application (consult the ZPL II Programming Guide).
A label format was sent to, but not recognized by, the printer.
■
Is the printer in pause mode? If so, press the feed button.
■
If the status LED is on or flashing, refer to “What the Status LED is
Telling You” on page 37.
■
Make sure the data cable is correctly installed.
■
A communications problem has occurred. First, make sure that the
correct communications port on the computer is selected. Refer to
“Communicating with the Printer” on page 18.
980410-001 Rev. B 41

Zebra TLP 2844-Z Specifications

General

Resolution	203 dpi
Media Sensors	Reflective and transmissive
Print Method	Direct Thermal
Print Width	4.09 inches
Max Print Speed	4 inches per second
Max Print Length	39 inches
Connectivity	USB, Serial, Parallel
Media Handling	Roll-fed, Fanfold
Label Roll Capacity	5" (127 mm) O.D.
Supported Barcode Types	Code 39, Code 128, UPC, EAN, Interleaved 2 of 5
Supported Media Types	Roll-fed or fanfold, die-cut labels with or without black mark, tag stock, continuous receipt paper, wristbands
Media Width	1.0" (25.4 mm) to 4.25" (108 mm)
Media Thickness	0.003 inches (0.08 mm) to 0.0075 inches (0.19 mm)
Operating Temperature	40°F (5°C) to 105°F (41°C)
Storage Temperature	-40°F (-40°C) to 140°F (60°C)
Power Requirements	100-240 VAC, 50-60 Hz