page 3 of 4
Connect the Printer to a Power Outlet
Power on the printer
Press up to turn ON or down to turn OFF the printer.
Calibrate the Printer
1. Make sure media is loaded
2. Turn on the printer power
3. Press and hold the Feed button until the green status light flashes once,
then twice – now Release the Feed button
2. The printer will set the media sensor for the label being used. After it is done
making this adjustment, the fanfold will automatically feed until a label is
positioned at the printhead.
5. Press the Feed button. One entire blank label will feed.
To Next Page
Loading...