MP7000 BRACKET INSTALLATION GUIDE
Assembly Requirements
•
Large, flat work space.
•
Package containing one sheet metal filler rail and one Torx screw with a colored thread lock patch (7 mm/.28 in. long).
•
T20 Torx screwdriver.
Assembling the Bracket
To assemble the bracket:
1. Remove the scale platter on the MP7000 device and place it to the side.
2. Lay the MP7000 device flat on one side to show the side screws. Remove the Torx screws (12 mm/.47 in. long, 2 places) as shown and keep them to
the side.
3. Lay the MP7000 device flat on its bottom.
a. Verify that the sheet metal rail fits onto the MP7000.
b. Align the hole on the rail with the hole closest to the front of the MP7000.
c. Secure the rail to the device with a colored screw from the package.
MN-003573-01 Rev A 6/19
To Next Page
