980515-001 Rev. C P110i & P110m Card Printer User’s Manual 7
2
Printer Installation
Installing the P110i or P110m Printer
Caution • Do not power the printer with USB attached to your computer at this
time.
THE DRIVER WILL PROMPT YOU WHEN IT IS TIME TO PLUG IN AND POWER
UP YOUR PRINTER.
Caution • Limit electrical power supplied to the P110i or P110m Printer to 24
VDC. Limit excess current draw to 16 amps or less, using an associated circuit
breaker or other such device. Never operate the printer in a location where
operator, computer, or printer can get wet. Personal injury could result. The
printer must be connected to an earthed electrical power supply and properly
protected against electrical surges and grounding faults. The power supply pack
can only be replaced by the same product from the manufacturer.
To Next Page
Loading...
