980584-001 Rev. A Zebra P110i / P110m / P120i Card Printers Service Manual 29
Back Overlay Varnish - Feature selection for applying overlay varnish ribbon to back of
card. Default setting is full edge-to-edge varnish.
There are various varnish options. A preview pane is shown for each selection.
• Full overlay varnish - Applies an edge-to-edge overlay
• No overlay - Does not apply any overlay
• Selected Area - Applies overlay only in the area selected by user
• Selected area blank - Applies overlay only outside the area selected by user
• Bitmap based overlay - Applies a user-defined bitmap in the overlay panel
• Smartcard ISO - Does not apply overlay in the area of the ISO standard Smart Card
contacts
• Smart Card AFNOR - Does not apply overlay in the area of the AFNOR standard
Smart Card contacts
• Magnetic Stripe - Does not apply overlay in the area of the ISO standard
Magnetic Stripe
Hologram Overlay Varnish - Feature selection for applying hologram overlay varnish ribbon
to the front of card. Does not apply to this printer.
There are various varnish options. A preview pane is shown for each selection.
• Full overlay varnish - Applies an edge-to-edge overlay
• No overlay - Does not apply any overlay
• Selected Area - Applies overlay only in the area selected by user
• Selected area blank - Applies overlay only outside the area selected by user
• Bitmap based overlay - Applies a user-defined bitmap in the overlay panel
• Smartcard ISO - Does not apply overlay in the area of the ISO standard Smart Card
contacts
• Smart Card AFNOR - Does not apply overlay in the area of the AFNOR standard
Smart Card contacts
• Magnetic Stripe - Does not apply overlay in the area of the ISO standard
Magnetic Stripe
To Next Page
Loading...
