20 P110i User’s Manual 980515-001 Rev. A
P110i Printer Setup
Loading Cards
4. Holding the card deck by the sides, hold it vertically against a flat surface such as a
desktop. If the deck is too thick for your hand to hold it comfortably, use about half a deck
at a time.
5. Push the stack back and forth to an angle of about 45° from vertical, so as to separate all of
the cards.
6. Restore the card stack to its original squared-off condition, and place the cards in the input
hopper.
7. Place stack of up to 100 cards into card feeder and close the card feeder cover. When card
feeder cover is closed, the card guide locking mechanism will automatically be released.
CARD FEEDER
COVER
CARD
STACK
CARD
FEEDER
To Next Page
Loading...
