28 P120i Card Printer User Guide 980504-001 Rev. A
Printer Installation
Complete Printer Installation
Connect the P120i Printer
The following instructions will guide you through the installation of the P120i printer.
1. Place the printer in a location that allows easy access to all sides. The printer should never
be operated while resting on its side or upside down.
2. Remove the yellow CAUTION label from the back of the printer.
3. Ensure that the printer’s power switch in the OFF ( O ) position.
Caution • Limit electrical power supplied to the P120i Printer to 24 VDC. Limit excess
current draw to 16 amps or less, using an associated circuit breaker or other such
device. Never operate the printer in a location where operator, computer, or printer can
get wet. Personal injury could result. The printer must be connected to an earthed
electrical power supply and properly protected against electrical surges and grounding
faults. The power supply pack can only be replaced by the same product from the
manufacturer.
To Next Page
Loading...
Need help?
General
